Benjamin Moore Alkyd Low Lustre Enamel, Satin Impervo
A premium quality, low lustre, alkyd enamel. Satin Impervo® Alkyd Low Lustre Enamel (Z235) possesses superb leveling and hiding qualities, and is easy to apply with brush, roller or spray gun. It has excellent sag resistance, clings to sharp edges and corners. It reaches its normal satin finish in one week.
Recommended for use on metal and substrates such as steel, wrought iron and aluminum. Do not apply directly to galvanized metal. Note: All alkyd-based enamels experience a certain amount of yellowing. This effect is accelerated in dark or poorly ventilated areas.
*For metal substrates only*
USE COMPLETELY OR DISPOSE OF PROPERLY. This product
contains organic solvents which may cause adverse effects to the
environment if handled improperly. Emptied containers may retain
product residue. Follow label warnings even after container is
emptied. Residual vapors may explode on ignition.
- Easy to apply with brush, roller, or spray gun
- Covers surfaces in one coat, provided they are in good repaint condition and color change is not extreme
- Excellent washability
- Rust preventative coating
- Possesses superb leveling and hiding qualities
- Excellent sag resistance
- Clings to sharp edges and corners
- Do not apply when air and surface temperatures are below
50 °F (10 °C)
| Type | Interior |
|---|---|
| Coverage | 500- 550 sq. ft. per Gallon |
| Brand | Benjamin Moore |
| Series/Sub-Brand | Satin Impervo |
| Color Family | Tintable |
| Finish | Satin |
| Material | Oil-Based |
| Manufacturer Code | Z235 |
Surfaces to be painted must be clean and free from wax, oil, grease, dust, rust, loose paint and water soluble materials. Glossy areas should be dulled. If mildew is evident, it must be removed by application of a commercial mildew wash. CAUTION: Follow manufacturer’s application and safety directions.
New surfaces should be fully primed, and previously painted surfaces may be primed or spot primed as necessary. For best hiding results, tint the primer to the approximate shade of the finish coat, especially when a significant color change is desired.
New shiny non-ferrous metal surfaces that will be subject to abrasion should be dulled with very fine sandpaper or a synthetic steel wool pad to promote adhesion
Do not thin
Coverage: 500- 550 sq. ft. per gallon
Clean Up: Paint Thinner/Mineral Spirits
Dry Time: To Touch 4 Hours
– To Recoat 16 Hours
