Chat with us, powered by LiveChat

Simiron Instant Patch, 100% Solids Polyurea Pourable Crack Filler, 1 Gallon Kit

In stock
SKU
40002862
 
 

Simiron INSTANT PATCH is a two-component, 100% solids polyurea crack filler. This fast-curing formula allows for quick concrete repair to cracks, joints, holes and other damaged concrete surfaces. Simiron Instant Patch has a low viscosity formula that provides excellent adhesion to concrete, creating a permanent repair to damaged concrete surfaces. Instant Patch fast cure time allows repaired areas to be opened to traffic in as little as 10 minutes.

Recommended uses: Rebuild joint sidewalls, High traffic area spalls & crack repairs, Quick repair in busy areas, Floor repair & reconditioning, Fill small concrete defects before coating, Used to “knit” cracked slabs, Repair concrete to prevent further damage

$90.00
each
Select a store
17 Available in stock
Delivery
Available
  • Fast Return-to-Service
  • Pourable
  • Easy 1:1 Mix Ratio
  • Zero VOC, 100% Solids Polyurea
  • No Odor and Solvent-Free Formula
  • Excellent adhesion to concrete
  • Impact Resistance
  • Cures at temperatures as low as 0°F (-18°C)
  • Can be mixed with silica sand as a filler
More Information
TypeCrack Filler
Size1 Gallon Kit
ColorConcrete Gray
BrandSimiron
Material100% Solids Polyurea
Manufacturer Code40002862

Surface Preparation: Concrete should be a minimum of 28 days old. All dirt, oil, dust, paint, grease and other foreign materials must be removed to assure adhesion to concrete. For repair of spalled concrete or pop-outs, use a still wire brush or twisted wire wheel to remove any loose, unsound or deteriorated concrete before application. Cracks must be chased and cleaned with a diamond crack chasing blade on a handheld grinder. After preparing area, remove all dust and debris with a vacuum. All surfaces must be clean and dry before filling with Instant Patch.

Application:

  1. Simiron Instant Patch has a mix ratio of 1 part Base to 1 part Activator by volume. Mix or shake both components separately before use.
  2. Premeasure equal amounts of Base and Activator before mixing together. Mix Base and Activator by stir stick or paddle mixer for 20-30 seconds. Only mix enough material that can be used within 2-3 minutes after mixing.
  3. Adding Silica Sand Be sure silica sand is dry and doesn’t contain any moisture before mixing with Instant Patch. For best application and usage premeasure Base, Activator and silica before mixing; do add more than one part silica to mixture. Add silica to base and premix together to ensure equal consistency. Premixing the silica into the base will make the mixing process easier when adding the activator and maximize working time. Add Activator to the pre-mixture of base and silica and mix for 20-30 seconds.
  4. Allow material to cure 10-15 minutes
  5. Grind epatch material level if needed. 
  6. Coat over patches if desired. 
  7. Do not thin product with any solvents.
  8. Application Temperature Range Instant Patch can be applied in temperatures ranging from 0°F (-18°C) to 120°F (49°C). 

Dry Time: Tack freee in 5 minutes, Light Traffic 10 Minutes, Heavy Traffic 30 Minutes applied at 72°F (22°C) temperature relative humidity. 

Clean Up: Clean up mixing and application equipment immediately after use. Use acetone or xylene; do not use alcohol. Follow solvent manufacturer’s safety instructions. Be sure to follow all local, state and federal regulations when disposing of materials.

Write Your Own Review
You're reviewing:Simiron Instant Patch, 100% Solids Polyurea Pourable Crack Filler, 1 Gallon Kit
Your Rating