TimberTech® Impression Rail Express® 36 in., (Build Your Own)
Impression Rail Express® is contemporary, strong, and unobstructive. Lean into a minimalist railing profile with this pre-assembled, aluminum panel that keeps sightlines clear and balusters rattle-free by being locked in place. Sleek, strong, and minimalist, this railing profile features hidden fasteners and fades into the background to keep your stunning view the star of your outdoor living space.
* Stair railing panels are shipped at a 37 degree angles. Panels are adjustable +/- 3 degrees. Maximum post spans on stair railing application is 96 in. on center. Additional posts are required on any stair application more than 8 ft. in length.*
- SUPERIOR DURABILITY: Resists fazing, staining, and scratching
- MOISTURE-RESISTANT: Resists rotting, cracking and corrosion
- Narrower balusters for a less obstructed view (up to 30% less than competitors)
- Panelized railing system for a quick install (no fastening of individual balusters)
- Actual Level Panel Lengths Are as Follows: 6 ft. Panels = 69.43 in., 8 ft. Panels = 91.31 in
- Actual Post Size: 3 in. x 38.25 in. Skirt Outside Dimensions 5.38 in. x 5.38 in., Cap outside dimensions 3.39 in. x 3.39 in.
Appropriate fasteners for mounting posts to deck, miter saw with carbide tipped non-ferrous blade, cordless drill, tape measure, level, power cords, drop sheets and safety glasses, 3/16" Drill bit, 6" #2 Square drive bit, Installation jig (optional).
Prior to construction, check with your local regulatory agency for special code requirements in your area. Common railing height is 36" or 42".
Post spans will vary depending on job site conditions. Never span more than 8 ft. on-center between railing posts. Spans longer than 12 ft. in length will require reduced post spans. 3 in. posts are required to reach 6 ft. and 8 ft. lengths. 2 in. posts must be set in-line to panel.
Do not install post caps and vinyl post base covers until railing assembly is completed. 3 in. posts are required at all transitions. 2 in. posts may not be used to start/end a run or to form a corner. The top snap covers should snap firmly onto the aluminum railing channels.
Do not use a hammer. The top rails will snap by applying pressure from one end to the other. If you’re having issues snapping on the covers, check the clips to ensure that they are bottomed out into the aluminum railing channels. Foot Blocks must be installed BEFORE installing Top Rail Snaps.
Write Your Own Review