SEAL-KRETE® High Performance Floor Coatings, Clear-Shell TX, Slate Gray, Satin, Gallon Kit

Resin Type: Aliphatic Urethane

Application: Apply only when air, material and floor temperatures are between 50-90°F (10-32°C). Do not apply in direct sunlight or when temperature is rising. Be sure the substrate is completely dry. Pour out only the amount of material to be used into a roller pan. Unused material can be saved in the mixing container for up to 6 months provided it is properly sealed. Do not return unused material from the roller pan to the mixing container. Use a 3/8 in. lint free roller with a phenolic core to roll out the coating. Begin with rolling out a W or M pattern, then cross roll to fill in and smooth out the coating.

Coverage: 400 sq. ft. per gallon, Coverage rate can vary depending on the texture and porosity of the concrete

Dry Times: Recoat in 4-12 hours, Light Traffic 4-6 hours, Vehicle Traffic 24 hours

Pot Life: 6 months once stabilizer/tint has been added

Mixing Ratio: Both components and environment should be pre-conditioned to a minimum of 50º F (10º C) prior to use. Be sure the air and surface temperatures are at least 5º above the dew point. Clear-Shell TX is moisture sensitive, so be sure the outside of the containers are dry and free of condensation. Shake the container of Stabilized/Tint for one full minute before combining with the Clear-Shell TX. The components can be mixed in a separate container or mixed in the gallon can. After combining the components, power mix at 500-700 rpm for 2-3 minutes. Use an appropriate size mixer and use care to not entrain air into the coating while mixing. Once mixed, the material has a 6 month shelf life.

Clean Up: Clean tools and application equipment immediately after use with an active solvent like Methyl Ethyl Ketone (MEK).