A new generation of waterborne, acrylic emulsion pool paints which can be applied over most types of pool coatings in good condition, as well as bare concrete or plaster surfaces. WR-1000 Series pool paint can be applied to slightly damp surfaces, dries quickly for recoating, and withstands continuous submersion in fresh and salt water.
Where to use: Pools, Fountains. Waterborne Pool Paint is designed for use on concrete, Marcite, and Gunite surfaces. The integrity of the Marcite or Gunite must be sound and solid. Do not use in hot tubs and spas due to high water temperatures. We do not recommend painting stainless steel, aluminum, galvanized, fiberglass, steel or vinyl lined pools with this product. WR1XXX Series is compatible over any type or previously applied pool paint.
Application: Stir product thoroughly to assure uniform pigment dispersion. This product is self-priming on the substrates listed above. This product is formulated to be applied without thinning. If thinning is required, thin only with clean water. This product can be applied by Brush, Roller or Spray. Roller application is preferred. Follow spread rate recommendations. Do not apply heavier than recommendations. Always apply two coats of pool paint. Brush: Synthetic bristle / Roller: Nylon or other synthetic roller cover.1/4 inch –1/2 inch nap.
Coverage: 300-400 Sq. Ft. per gallon
Clean-up: Clean up with warm soapy water
Dry Time: Tack Free in 30 minutes, To Recoat in 4 - 6 hours, Full Cure 7 days outdoor, 14 days indoor. High humidity and cool temperatures will result in longer dry, recoat and service times.