INSL-X High Build Peel Bonding Primer, White, Gallon
A water-based, acrylic primer designed to smooth, seal, and extend the life of weathered surfaces. It applies as a milky white color for ease of visibility during application and top coating. High Build Peel Bonding Primer glues down peeling, cracking, or chalking paint, reducing surface preparation. It provides a mildew-resistant coating and is effective in blocking stains from rust as well as mild tannin bleed. It is recommended to topcoat with water-based paint.
Recommended For Limitations, Use on interior and exterior surfaces including drywall, plywood, wood siding, fences, stucco, concrete, and galvanized metal in residential and commercial applications.
- Available Colors: White
- Resin Type: Acrylic
- Glues down and stops peeling paint
- Remains flexible over time
- Provides a mildew-resistant finish
- Low-VOC
| Series/Sub-Brand | Insl-X |
|---|---|
| Type | Interior/Exterior |
| Size | Gallon |
| Color | White |
| Brand | INSL-X |
| Material | Water-Based |
| Manufacturer Code | BP1100099-01 |
Application: High Build Peel Bonding Primer applies easily with a quality brush, roller, airless or conventional spray methods. Stir product thoroughly before using. For best results, it is recommended to apply by brush or roller application to effectively work primer into surface pores. If applying by airless sprayer, it is recommended to use a unit with a minimum of 2,000 PSI of pressure with a 0.018 – 0.022 fluid spray tip. When applying by airless sprayer, it is recommended that the surface area should be back-rolled/brushed to insure proper adhesion, even application and effectively work primer into surface pores. It is important to maintain a wet edge during all methods of paint application by brushing or rolling into previously applied coating area.
For a high-build application, apply at a spread rate of 80 sq. ft. per gallon, at 20 mils (wet film thickness). Apply when surface and ambient temperature are above 35 °F and below 90 °F. Avoid paint application outside when weather conditions are threatening, and late in the afternoon when there is a threat of moisture condensing on wet primer. Do not prime if surface temperature is within 5 °F of the dew point.
Dry Time: 1 hour to touch, 2 hours to recoat.
Clean-up: Remove all spatters immediately with soap and water. Wash all equipment with soap and water immediately after use.
Coverage: 150 - 350 Sq. Ft. per gallon
Apply when surface and ambient temperatures are above 35 °F and below 90 °F. Not for use on floors, decks, or other walking surfaces Not for immersion service or areas of pooling water