3M PPS Series 2.0 Spray Gun Adapter #S18, 3/8 in. Female, 18 Thread NPS
*Check comprehensive spray gun list before ordering to ensure compatibility with your equipment.
The 3M™ PPS™ Series 2.0 Spray Cup System is our latest, best-performing disposable spray cup system. The system has been redesigned from the connection to the cup, and has been improved in six ways offering a complete disposable spray cup solution for mixing/measuring, filtering, spraying and for temporary sealing and protection of sprayable coatings.
The 3M™ PPS™ Series 2.0 Adapter, Type S18 is for use with the 3M™ PPS™ Series 2.0 paint preparation system H/O Pressure Cups (400 ml (13.5 oz.) and 850 ml (28 oz.). This adapter is compatible with many pressure feed and siphon feed spray gun models allowing the use of the 3M™ PPS™ disposable cup system.
- Only one PPS™ Series 2.0 cup for mixing and spraying
- Up to 70% savings of cleaning solvent
- Faster system - from mixing to disposal
- Less operator exposure to solvents and reduction in VOCs
- Spray gun functions at any angle
- When removing the lid and liner from the hard cup, twist lid to unlock, place fingers through hole in bottom of cup and push liner upwards, releasing lid and liner together.
- Use the wide base on your 3M™ PPS™ Series 2.0 Cup Sealing Plugs to stand your cups upside down when not in use, helping to keep the filter mesh wet.
- Eliminate traditional mixing cups and filters by mixing materials right inside your 3M™ PPS™ Series 2.0 Cups. Each lid contains a clean, welded-in filter.
| Type | Spray Gun Parts |
|---|---|
| Size | 3/8 in. |
| Style | HVLP |
| Brand | 3M |
| Series/Sub-Brand | PPS Series 2.0 |
| Material | Stainless Steel |
| Pack Size | 1-Pack |
| Manufacturer Code | 26054 |
3M™ PPS™ Series 2.0 Adapter provides four points of connection from lid-to-gun and converts typical spray guns into ones that work with the 3M™ PPS™ Series 2.0 Spray Cup System. Specifically designed adapters allow painters to use PPS™ with virtually any spray gun model. To use this adapter, remove the existing spray gun cup. Then simply thread the correct PPS™ Adapter into the spray gun.