Veto Pro Pac TP3 Tool Pouch
The TP3 tool bag is a clip-on diagnostics bag which holds a meter and a variety of tools. It clips onto any model Veto tool bag’s tape clip or D-Rings. The TP3 tool pouch is a clip-on diagnostics tool storage bag designed to hold a meter and a variety of tools.
When not in use it can clip onto any model Veto tool bag’s tape clip or D-Rings. It features 15 pockets of various sizes that will accommodate the most commonly used tools to diagnose and repair problems on service calls.
- Height (H): 9.5 in. (24cm)
- Width (W): 5.5 in. (14cm)
- Depth (D): 5 in. (12cm)
- Weight (empty): 1 lb. (.5kg)
- Max Payload: 10 lbs. (4.5kg)
- Internal Volume: 90 cu.in. (1.5L)
$59.95
each
- Vertical Tool Pockets: 4 inside & 11 outside
- 3 Long Shanked Tool Pockets
- 1 Meter Pocket
- D-Rings: 2 small
- 8 in. Electrical Tape Strap
| Type | Tool Pouch |
|---|---|
| Manufacturer Code | VPP10074 |
VETO PRO PAC TOOL BAGS PRODUCT CARE AND MAINTENANCE
Keep the Zippers Clean & Lubricated
Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.
Protect the Zippers From Sharp Objects and/or Excessive Heat
Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.
Don’t Overstuff the Bag
Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed… proceed with caution!
Write Your Own Review