Meoded Tonachino Firenze™ Lime Based Plaster Sand Finish

Surface Preparation & Application: Surface should be smooth, clean and free of contamination. Prime new sufaces with a PVA primer and let dry completely. Apply one coat of Meoded Quartz Primer™ allowing it 3-5 hours to dry. Sand existing surfaces. Use a stainless steel trowel to apply Tonachino Firenze™.

First Coat: Apply first coat in the same fashion you would apply a standard joint compound: in a smooth even fashion leaving a wet edge to avoid lap marks. While the plaster is still moist, it is recommended to use a wet sponge or a plastic float to create a more uniform design. Allow at leasy 12 hours to dry.

Second Coat: If required to smooth, lightly sand first coat with 180-320 grit sandpaper before proceeding. Apply the second coat in the same manner as the first coat. While Firenze ™ is still moist, it is recommended to use a wet sponge or a plastic float to create a more uniform design. To avoid formation of dark trowel marks it is recommended to smooth with a plastic trowel or Meoded’s WhiteOut trowel.

Smooth Finish: While the second coat is settling on the wall, roughly 5 minutes after application, it is recommended to smooth Tonachino Firenze™, with a plastic trowel or Meoded’s WhiteOut, Trowel to avoid formation of dark/black trowel marks.

Dry Time: 48 hour dry time
Apply: Using Stainless Steel Trowel
Clean Up: With water, immediately after use.
Dilution: None needed
Coverage:
One Quart (1.0 KG (2.2 lbs)) roughly 6.5-7 sq ft
One Gallon (5.0 KG (11lbs)) roughly 32.5-35 sq ft
One Bucket (20 KG (44lbs)) roughly 130-140 sq ft
Tonachino Firenze™ is in regards to its 2 coat application.
Top Coat: After 48 hours of drying, apply Meoded's penetrating sealer to provide protection