Sansin Purity Interior Clear Water-Based Finish, Satin, Gallon
Purity Clear is a beautiful 2 coat interior clear finish meant to intensify the grain and deepen wood’s natural color (anfeuerung) on windows, walls, furniture and other wood surfaces. Available in Gloss, Satin, Low Lustre and Extra Low Lustre. Low in VOC’s, environmentally friendly, easy soap and water clean-up.
Purity Clear is a two-coat finish that enhances the natural warmth of wood. A two-coat, high solids finish that enhances the natural warmth of wood and intensifies the grain – especially suited for light-colored woods, like pine and cedar, where a mellow tone is desirable. A popular choice for log and timbers. Available in extra low lustre, low lustre, satin, and gloss.
Purity Clear is UV resistant, washable, environmentally friendly, low in VOC’s, high in solids and non-flammable with easy soap and water clean-up. Available in low lustre, satin and gloss formulations.
Recommended for: Windows, ceilings, walls, furniture and other fine wood surfaces. For optimum UV protection or if a special color or toning is desired, use a pigmented version of Sansin Purity Interior Stain as the first application.
- Interior topcoat
- Fast drying
- Low VOC
- Clean-up with water and soap
- Non flammable
- Enhances woods character
- Penetrates wood surface
- Water repellent
- UV Resistant
| Type | Interior |
|---|---|
| Size | Gallon |
| Color | Clear |
| Coverage | 300-500 Sq. Ft. per gallon |
| Brand | Sansin |
| Finish | Satin |
| Material | Water-Based |
| Manufacturer Code | 3110/1 |
Surface Preparation: Remove all hardware or cover hardware that cannot be removed. Surface must be dry and free of contaminants such as waxes, silicones, glues and dirt. Do not use steel wool or anything that may leave iron particulate on the wood surface. Repair any defects in the surface, such as holes and cracks using only quality, acrylic-based tinted, wood fillers to match the color of the project. Wood filler must be allowed to dry completely prior to sanding. Extra effort in sanding will pay off in aesthetics. Use 120-150 grit sandpaper and always sand with the grain for best results. Remove dust particles by vacuuming and wipe with damp cloth. Test formula on an inconspicuous wood surface to ensure proper color and penetration.
Application: Apply the first coat of Sansin Purity Interior Clear by sprayer or with a nylon polyester brush or pad applicator. Spread the finish evenly. Purity Clear has excellent leveling properties; be careful not to overwork the product. For spray application use conventional or air assist airless, avoid high sheer pumps. Contamination in pump can cause cratering or other surface issues. Equipment should be qualified before use. Test formula on an inconspicuous wood surface to ensure proper color and penetration.
Dry Time: Allow 4 hours drying time in proper conditions when the temperature is between 60ºF-70ºF (15ºC-20ºC) and the relative humidity is no higher than 70%. If necessary, after the surface is completely dry, sand lightly using 220-320 grit sandpaper or a fine synthetic abrasive pad. Always sand with the direction of the grain. Vacuum the surface and wipe with a damp cloth to remove all dust particles. Apply the second coat of Sansin Purity Interior Clear. For additional protection or gloss, a third coat may be applied after 24 hours.
Coverage: 300-500 Sq. Ft. per gallon.
Clean Up: Soap and water.