Rust-Oleum® Painter’s Touch® 2X Ultra Cover® Primers provide a sound base for application of Painter’s Touch 2X Ultra CoverEnamels on wood, metal, plastic and more. Use of primers promotes topcoat adhesion and helps prevent chipping, cracking and peeling. Use of these primers eliminates the need for multiple coats of enamel finish. It covers surfaces with less spray passes, allowing projects to be completed faster and easier. Any angle spray feature allows you to spray in any direction, even upside down for those hard to reach areas. Contains a comfort spray tip with a wider finger pad to reduce fatigue caused by continuouse spraying. Fast Drying.
TIP: Some plastics made of polyethylene such as plastic storage containers are manufactured in a way that may hinder maximum paint adhesion. Test paint in a hidden area first.
Recommended for:
Series/Sub-Brand | Painter’s Touch® |
---|---|
Type | Spray Paint |
Size | 12 oz. |
Color | Red |
Brand | Rust-Oleum |
Color Family | Red |
Finish | Flat Primer |
Material | Oil-Based |
Manufacturer Code | 334018 |
Surface Preparation: Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable leaning method. Rinse with fresh water and allow to thoroughly dry. Remove loose paint and rust with a wire brush or sandpaper. Previously coated surfaces must be sound and in good condition. Smooth, hard, or glossy finishes should be scarified by sanding to create a surface profile.
Application: Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90ºF (10-32ºC) and humidity is below 65% to ensure proper drying. Do not use on objects that may exceed 200ºF (93ºC) surface temperature. Do not apply to galvanized steel.
Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist. Shake can vigorously for one minute after mixing ball begins to rattle. If mixing ball fails to rattle, DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 10-16" from surface and spray in a steady back-andforth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. Apply 2 or more light coats a few minutes apart to avoid drips and runs. Do not use near open flame.
Recoat: Dry and recoat times are based on 70ºF and 50% relative humidity. Allow more time at cooler temperatures. Dries to touch in 20 minutes, to handle in 1 hour, and is fully dry in 24 hours. Apply a second coat or clear coat within 1 hour or after 48 hours. Apply clear in 2-3 light coats a few minutes apart.
Note: On plastic maximum paint adhesion and durability is achieved in 5-7 days.
Clean-Up: When finished spraying, wipe off tip before storing. Clean up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in home trash compactor.