Rust-Oleum® LeakSeal, Rubberized Spray Coating, Clear, Semi-Gloss, Oil-Based, Spray Paint, 12 oz.
Rust-Oleum® LeakSeal® Flexible Rubber Coating is an easy to use, rubberized protective utility coating designed to fill gaps & cracks up to 1/4” and seal out water, air & moisture. It provides a watertight, weatherproof barrier that also protects the surface from rust. LeakSeal dries to a semi-smooth, firm finish that will not sag or drip, and can be top-coated with latex or oil based paints. Designed for use on metal, aluminum, galvanized metal, PVC, concrete, masonry, asphalt roofing materials, vinyl, fiberglass, and more. Not recommended for rubber surfaces or surfaces exposed to continuous water immersion.
As low as
$23.99
each
Not recommended for rubber surfaces & continuous water immersion
| Series/Sub-Brand | LeakSeal® |
|---|---|
| Type | Spray Paint |
| Size | 12 oz. |
| Color | Clear |
| Brand | Rust-Oleum |
| Color Family | Clear |
| Finish | Semi-Gloss |
| Material | Oil-Based |
| Manufacturer Code | 265495 |
Surface Preparation: Remove all dirt and debris from the area to be coated. Wash area with a detergent and water solution, rinse with fresh water, and allow the surface to dry thoroughly. Remove any loose paint or previous coatings with a wire brush or sandpaper. Lightly sand glossy surfaces. Wipe the sanded surface clean when finished.
Application:Use outdoors or in a well ventilated area such as an open garage. Apply when temperature is between 50-90°F (10- 32ºC) and humidity is below 65% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200ºF (93ºC). Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. A test spray on cardboard is recommended to obtain feel for the spray pattern. Hold can 8-18” from the surface and spray in short even strokes. It is recommended to apply a light first coat. Apply a second heavier coat to ensure proper coverage. A thicker film can be achieved by moving the nozzle closer to the surface. Initial spray may have some foaming or bubbling, but will dissipate as the coating dries. For best results, apply 2 coats. Allow to dry 15-30 minutes between coats.
Recoat:Dry and recoat times are based on 70ºF and 50% relative humidity. Allow more time at cooler temperatures. Dries to the touch in 2 hours, but additional coats can be applied after 15-30 minutes. Allow 24 hours for full cure.
Clean-UpWipe off tip when finished. Clean-up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in home trash compactor.
Clogging: After use, turn can upside down and press spray nozzle until spray is clear to prevent clogging. If the valve clogs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into can valve opening.
Write Your Own Review