Great Stuff Pro Windows & Doors Insulating Foam Sealant for Gun, 20 oz. Can
Flexible without compromise, GREAT STUFF PRO™ Window & Door Polyurethane Foam Sealant quickly and cleanly forms airtight, water-resistant seals between framework and rough openings with the precision professionals expect.
Flexible without compromise, GREAT STUFF PRO™ Window & Door Polyurethane Foam Sealant quickly and cleanly forms airtight, water-resistant seals between framework and rough openings with the precision professionals expect.
$17.99
each
- Reusable for 30 days when left attached to GREAT STUFF PRO™ Dispensing Gun
- Forms a long-lasting, airtight, weather-resistant seal (GS-119)
- Soft, pliable, easy to stuff back into the gap without trimming
- Expands and contracts to allow for various weather conditions.
- Bonds to vinyl, wood and metal frames
- Fireblock formulated
- Offers greater insulation value than chinked fiberglass or caulk (GS-130)
- Tack-free in 3-10 minutes1; trimmable in one hour
- Paintable, stainable and sandable (GS-120)
- Yellow-colored foam for easy identification
- UL classified
| Type | Window & Door |
|---|---|
| Size | 20 oz. |
| Style | Gun |
| Brand | Great Stuff |
| Manufacturer Code | 187273 |
- Shake vigorously for a minimum of 60 seconds. If the can sputters, simply shake the can while held upside down.
- Any uncured product that gets on the skin can be removed with acetone.
- Best results if used when product temperature ranges from 60-90°F (15-32°C). The can should not be exposed to temperatures more than 120°F. Cured foam should not be exposed to temperatures in excess of 240°F.
- Firmly screw straw assembly onto valve and dispense SLOWLY.
- Mist with water to speed cure.
- Trim cured foam with serrated blade.
- If applied outdoors, be sure to paint or cover foam to prevent discoloration and UV damage.
- If using GREAT STUFF PRO™ with the Foam Dispensing Gun, follow these additional steps before application:
- With the can secured, set your desired bead size by adjusting the flow control knob on the back of the gun (bead can be adjusted from 1/8"-3"). Then, pull the trigger to fill the gun with foam, dispensing excess foam into an appropriate waste receptacle. Lastly, test the bead size before applying.
- Tighten the flow control screw until fully closed for storage. Use can within 30 days of initial use.
- Store upright with a foam dispensing gun attached.
- Fill gaps <50%
- Always leave a can of foam attached to the gun with the flow control screw closed.
- When ready to change cans, shake the new can of foam for a minimum of 60 seconds.
- NEVER leave a gun without a can of adhesive without a can of Great Stuff Pro™ attached unless the gun has been thoroughly cleaned with Great Stuff™ Foam Cleaner.
Write Your Own Review
