Sansin Wood-Strip, Gallon

Surface Preparation: Substrate must be dry. Temperature above 20°C (70°F). Spray vegetation with water or shield off before and during application. Protect bordering areas with drop sheets and/or tape off with poly. Do not allow this product to contact metal, fabric, floor coverings or outdoor furniture.

Application: Apply liberal and uniform application using brush, roller or sprayer. On vertical surfaces start at the bottom and work your way up. Do not allow to dry as this will require reapplication. Must lightly mist with water to keep active. Do not apply in direct sunlight. Allow the product to dissolve coating for at least 20 minutes. During waiting period you may agitate coating using a stiff brush; always agitate in direction of wood grain. Thoroughly rinse the surface using a garden hose or low pressure power washer (max pressure 500psi). Direct the power washer wand with the grain of the wood. Do not stop the wand on the wood as this may mark the wood surface. Allow the wood to dry completely before proceeding to step 2 application of Wood Lightener.

STEP 2: Application of Sansin Wood Lightener® Dissolve the bag of Sansin Wood Lightener® into 1.5 - 2 gallons (5.75-7.5 L) of water, depending on the degree of brightening you require. Spray the Sansin Wood Lightener® evenly on cleaned wood surface. Allow the Sansin Wood Lightener® to neutralize the treated wood surface for at least 10 minutes. Rinse off with water. Allow the wood to completely dry before sanding. On smooth surfaces always sand using a variable speed random orbital sander with 60-80 grit sand paper to prepare a beautiful finish. See Directions for Use on Sansin Wood Lightener® bag.

Coverage: 100-200 Sq. Ft. per gallon

Dry Time: Do not allow wood-strip to dry on surface as this will require reaplication.

Clean Up: Spray vegetation with water or cover before and during application. Clean up equipment with water.