Frameport PR-1515 36 in. x 80 in. Primed, 15 Lite French Ovolo Interior Left-Handed Door Unit
Frameport America Doors offers a complete line of Primed doors. These French doors offer 15 Lite, with an ovolo sticking providing clean, rounded edges. The door's panel edges are kerfed and squeezed during panel insertion, allowing them to expand in the inside door frame, and eliminating rattling.
These 15 Lite Glass French MDF doors are Pre-hung units, framed with 4-9/16 in. Primed Finger-jointed Pine flatboard jambs with colonial stops, 2-3/8 in. standard single bore.
The casing is sold separately.
As low as $331.69
- Stile and Rail Construction
- Factory Sealed Top & Bottom Rails
- Doors Polybagged
- 5-Year Warranty
- Learn more about Interior Door Anatomy
- 3 Satin Nickel Hinges
| Type | Interior French Doors |
|---|---|
| Brand | Frameport America |
| Finish | Primed |
| Material | Pine |
| Door Type | Full Glass |
| Door Configuration | Single Pre-Hung |
| Door Style | Colonial, Traditional |
| Door Size | 36 in. x 80 in. (3/8 x 6/8) |
| Rough Opening | 38-1/4 in. x 82-1/2 in. |
| Door Swing | Left Hand |
| Door Thickness | 1-3/8 in |
| Jamb Type | 4-9/16 in. Flat Primed Finger-Jointed Jamb with Colonial Stop |
| Hinge Finish | Satin Nickel (US15) |
Storage & Handling
- Always handle doors with clean hands or while wearing clean gloves
- Doors should not be at a job site until concrete floors, foundations and plaster walls are thoroughly dry.
- Doors should not be exposed to excessive moisture, head, dryness or direct sunlight
Installation
- Doors should be conditioned to average prevailing relative humidity of the locality before fitting
- Do not cut doors down in size more than 1/2 in. width (1/4 in. each side) or 2 in. in height (1/2 in. from top of door, or up to 1-1/2 in. from bottom of door*)
- Allow 1/8 in. clearance between doro and frame at the top and sides of the unit.
- Be sure that jambs and stops are set perfectly square and plumb, shim and fasten every 2 feet.
- Use (3) hinges on doors 7 ft. or less in height
- Special preparataion is requed with mortise locks, please contact us for more information if needed.
Finishing
- Finish must be applied to the door immediately after fitting and hanging, but not during or immediately after high-moisture periods.
- Surfaces must beclean and dry
- Sand entire door lightly with 180 grit sandpaper
- Finish all (6) sides, this induldes edges, tops and bottoms.
Write Your Own Review