Frameport 30 in.x 80 in. 2 Panel Shaker Style Interior Door Right-Handed Unit
Frameport Wood Composite Doors are affordable, stylish and environmentally friendly interior doors. These primed doors are a combination wood Frame with MDF Panel making it in 1-3/8 in. door. These doors work great for all areas of the home.
This Shaker door has a smooth texture are Pre-hung units, framed with 4-9/16 in. primed finger-jointed flatboard jambs with bullnose stops, 2-3/8 in. standard single bore, and (3) 3-1/2 Radius Satin Nickel Hinges.
Casing sold separatley.
As low as $262.99
each
- Stile and Rail Construction
- Factory Sealed Top & Bottom Rails
- Doors Polybagged
- 5-Year Warranty
- Learn more about Interior Door Anatomy
- 3 Satin Nickel Hinges
| Type | Interior Doors |
|---|---|
| Brand | Frameport America |
| Finish | Primed |
| Material | Pine/MDF |
| Door Type | 2-Panel |
| Door Configuration | Single Pre-Hung |
| Door Style | Contemporary |
| Door Size | 30 in. x 80 in. (2/6 x 6/8) |
| Rough Opening | 32-1/4 in. x 82-1/2 in. |
| Door Swing | Right Hand |
| Door Thickness | 1-3/8 in. |
| Jamb Type | 4-9/16 in. Flat Primed Finger-Jointed Jamb with Bullnose Stop |
| Hinge Finish | Satin Nickel (US15) |
| Manufacturer Code | 8100204552 |
Storage & Handling
- Always handle doors with clean hands or while wearing clean gloves
- Doors should not be at a job site until concrete floors, foundations and plaster walls are thoroughly dry.
- Doors should not be exposed to excessive moisture, head, dryness or direct sunlight
Installation
- Doors should be conditioned to average prevailing relative humidity of the locality before fitting
- Do not cut doors down in size more than 1/2 in. width (1/4 in. each side) or 2 in. in height (1/2 in. from top of door, or up to 1-1/2 in. from bottom of door*)
- Allow 1/8 in. clearance between doro and frame at the top and sides of the unit.
- Be sure that jambs and stops are set perfectly square and plumb, shim and fasten every 2 feet.
- Use (3) hinges on doors 7 ft. or less in height
- Special preparataion is requed with mortise locks, please contact us for more information if needed.
Finishing
- Finish must be applied to the door immediately after fitting and hanging, but not during or immediately after high-moisture periods.
- Surfaces must beclean and dry
- Sand entire door lightly with 180 grit sandpaper
- Finish all (6) sides, this induldes edges, tops and bottoms.
Write Your Own Review