SEAL-KRETE® High Performance Floor Coatings, Color-Shell Concrete Stain, Red, 16 oz.
Seal-Krete® Color-Shell utilizes the latest in UV stable colorant technology offering a fast drying easy to apply concrete stain. Color-Shell creates unique, multi-colored translucent colors that will not peel, chip, or flake. Available in 20 standard colors which can be combined to create unlimited color possibilities. When properly sealed Color-Shell will resist staining and harsh chemicals.
NOTE: On-screen and printed color representations may vary from actual color once applied to concrete. Recommended to test an inconspicuous area before applying to the whole area.
- Concrete stain
- Variegated finish
- SCAQMD approved stain
- 20 Standard colors availble
- Ulimited possibilities of colors
- Fast drying - Topcoat in 1 hour
- Acid free
- Will not peel or flake
- Gloss and Matte Topcoats available
- Restaurant Floors
- Entry Ways
- Bar Floors
- Patios and Walkways
- Basement Floors
- Garage Floors
- Concrete Paver Refresh
- Stamped Concrete
- Retail Stores
- Showrooms
| Series/Sub-Brand | Seal Krete |
|---|---|
| Type | Interior/Exterior |
| Size | 16 oz. |
| Color | Red |
| Brand | Seal Krete |
| Color Family | Red |
| Material | Concrete Stain |
| Manufacturer Code | 980012 |
Mixing Instructions: For use with SEAL-KRETE High Performance Epoxy-Shell 1000 2-part epoxy clear kits. Mix 1 metallic pigment quart jar (32 oz) with 1 gallon Epoxy-Shell 1000 clear Part “A”. Mix thoroughly using a low speed drill with mixing attachment for 3 minutes. Add 1/2 gallon Part “B”. Mix an additional 3 minutes. Do not aerate the mix. Mix only the amount of material that can be poured and applied immediately during the pot life (approximately 30–45 minutes, depending on air/surface temperatures). The recommended application rate is 75 (24 mil) - 100 (16 mil) sq. ft. per gallon. This thickness will ensure that the metallic pigment can work its magic. During application, the pigments start to move and create a variegated appearance. Metallic color packs may vary in color. Premixing each metallic color pack to be used on a project is recommended.
For example, if a 3 gallon kit of Epoxy-Shell 1000 is going to be used on a project,
Follow these steps:- 1. Open both gallons of Epoxy-Shell 1000 Part “A” and transfer to a larger container
- 2. Add 2 – quart size (32 oz) metallic color packs
- 3. Mix thoroughly
For cutting in along a wall:
1. Use premixed material from above
Basic Finishing Techniques: Depending on the final look desired, the installer can use one of two generally accepted finishing techniques:
1. For a solid, brushed finish, apply using a magic trowel or flat squeegee. This ensures even product application. Check application coverage rate periodically during installation.
2. Start with step 1 above, after metallic has cured 10 - 20 minutes, spritz the floor with denatured alcohol. This loosens the surface tension, dissipates the pigment, removes trowel marks and creates high and low colors for a truly unique look. Only a small amount of alcohol is needed. One gallon of denatured alcohol should cover approximately 2000 sq. ft. The alcohol is best applied with a hand held trigger spray bottle using a coarse spray setting. The alcohol will evaporate and the final look will be achieved within about 1-2 hours.
NOTE: this application is not legal in SCAQMD due to VOC restrictions.