Chat with us, powered by LiveChat

TWP® 200 Series Shake and Shingle Sealant Stain 201 Cedartone, Gallon

In stock
Only %1 left
SKU
TWP201
 
 
WP® 200 SERIES is a professional strength, easy to apply, deep penetrating wood protectant system which protects wood from water absorption and ultraviolet light. TWP 200 Stain Series is a semi-transparent oil based penetrating finish designed to extend the life of exterior wood such as decking, cedar shake siding, and shingles. Containing a paraffin oil, TWP 200 series penetrates wood extremely well. The Paraffin oil is a "non-drying" oil that enhances the wood cells structural stability. For use on: Wood Shakes, Wood Shingles, Log Homes, Railroad Ties, Wood siding, Fences, Shutters, Fascia, Post & Beams.
As low as $52.49
each
  • Clear is not intended for color retention and will allow the wood to gray naturally.
  • High solids, low VOC
  • Mold and mildew resistant film
  • Restores woods moisture content
  • Deep penetrating oil formulation
  • Helps prevent warping, cracking & splitting
  • Easy to apply and maintain
More Information
Type Exterior
Size Gallon
Color Clear
Brand Total Wood Preservative
Material Oil-Based
Surface Preparation: This product must be applied to porous unsealed surfaces. NEW WOOD: All new wood must be thoroughly wetted by rain or tap water at least twice to open wood grain and remove excess surface tannins. Allow a minimum of 48 hours of good drying conditions before applying TWP. OLD WOOD: Prior to cleaning replace any cracked or severely cupped shingles. If surface is above 15% defective, it is advisable to re-roof. Pay special attention to ridge caps. For the best appearance use good aged shingles from the back of the house to replace unusable shingles in the front. This procedure will give the front of the home a more uniform appearance and keep the roof from having a blotchy appearance from the insertion of random new shingles. Replace shakes and shingles before cleaning. Application: After product selection and a minimum 48 hours of drying after cleaning, product may be applied. There are many pumping mechanisms to apply product. Avoid excessive overspray be adjusting pressure to minimize misting. Most commonly used is airless spray equipment in the ½ to 1 ½ gallon minimum pump capacity. The gun assembly should include a three foot extension pole with a .032 to .040 swivel wide angle spray tip. This will allow the application to stay away from the product and keep the spray close to the surface. It is preferred to spray a 3 foot section laterally across the roof and ending the bottom of the pattern as close to the shingle butt line as possible. This is done to avoid lapping. This is a one coat system. Note: This product is very dark upon application and can take as long as 8 weeks to lighten to the final color. Coverage: TWP should be applied at 100-250 sq.ft./gal. Rate will vary depending on wood porosity. Remove excess or puddled material that has not penetrated after 15 minutes on horizontal surfaces with a paint pad or dry roller. Single coat application only. Dry Time: Allow to dry for a minimum of 48 hours. 2-4 days depending on humidity. Cleanup: Use Mineral Spirits for equipment clean up
Write Your Own Review
You're reviewing:TWP® 200 Series Shake and Shingle Sealant Stain 201 Cedartone, Gallon
Your Rating